Skip to content
thecalculatorstudio

BTU Calculator: What Size Air Conditioner Do You Need?

Enter the floor area of the room, how sunny it is, how many people are in it and whether it is a kitchen. You get the cooling capacity in BTU per hour, with every adjustment shown.

Last reviewed

Cooling capacity needed

8,000 BTU/h

about 2,345 watts of cooling, for 300 square feet

From the ENERGY STAR chart
8,000 BTU/h

The chart assumes an 8-foot ceiling; with a higher ceiling, ENERGY STAR suggests a larger unit. Oversizing is a mistake too: a unit that is too big cools the room before it removes the humidity. Choose the nearest size the shops sell.

How to size a room air conditioner

An air conditioner’s cooling capacity is quoted in BTU per hour, the rate at which it removes heat from the room. Too small and it never cools the room. Too big and, as ENERGY STAR explains, it costs more, wastes energy, and cools the room before it has a chance to remove the humidity, which leaves the air cool and damp.

The ENERGY STAR method has three steps:

  1. Measure the floor area. Length times width, in feet. Split an awkward room into rectangles and add them up.
  2. Read the capacity from the chart for that area.
  3. Adjust for the circumstances below.

The ENERGY STAR cooling capacity chart

Area to be cooled (square feet) Capacity needed (BTU per hour)
100 up to 150 5,000
150 up to 250 6,000
250 up to 300 7,000
300 up to 350 8,000
350 up to 400 9,000
400 up to 450 10,000
450 up to 550 12,000
550 up to 700 14,000
700 up to 1,000 18,000
1,000 up to 1,200 21,000
1,200 up to 1,400 23,000
1,400 up to 1,500 24,000
1,500 up to 2,000 30,000
2,000 up to 2,500 34,000

The capacities are calculated for an 8-foot ceiling. With higher ceilings, ENERGY STAR suggests selecting a unit with higher capacity.

Adjustments

  • If the room is heavily shaded, reduce capacity by 10 percent.
  • If the room is very sunny, increase capacity by 10 percent.
  • If more than two people regularly use the room, add 600 BTU for each additional person.
  • If the unit is used in a kitchen, increase capacity by 4,000 BTU.

ENERGY STAR does not say in what order to apply them. The calculator takes the 10 percent on the chart figure first and then adds the fixed amounts.

Worked examples

  • A 300 square foot bedroom for two. It falls in the 300 up to 350 band: 8,000 BTU per hour, which is about 2,345 watts of cooling.
  • A 200 square foot sunny kitchen with four people. The chart gives 6,000. Sun adds 10 percent, which is 600. Two extra people add 2 × 600 = 1,200. The kitchen adds 4,000. The total is 6,000 + 600 + 1,200 + 4,000 = 11,800 BTU per hour.
  • A 20 square metre room. 20 ÷ 0.3048² = 215.3 square feet, so the chart gives 6,000 BTU per hour.

Choosing the unit

Room air conditioners come in set sizes, so pick the nearest size at or above your figure. If your figure sits just above a common size, think about the adjustments again: shade, a lower ceiling, or fewer people might bring it down. Do not jump a size or two for safety, since oversizing is a fault in itself.

When the chart does not apply

  • Rooms under 100 square feet are below the chart.
  • Spaces over 2,500 square feet are above it. A big open space or a whole house needs a proper load calculation, which takes in insulation, windows, climate and equipment.
  • Rooms with unusual heat sources, such as a server rack or a commercial oven, need special advice.

Common mistakes

  • Measuring wall area, not floor area. The chart uses the floor.
  • Sizing for the hottest day by adding extra. Oversizing wastes energy and leaves the room clammy.
  • Forgetting the kitchen. A kitchen adds 4,000 BTU.
  • Ignoring the ceiling. The chart assumes 8 feet.
  • Counting visitors. The 600 BTU applies to people who regularly use the room.

To find the floor area, use the square footage calculator. For the running cost of the unit, use the electricity cost calculator, and for other units of power, the power converter.

How it is calculated

BTU figures are whole numbers from the chart and the adjustments. A BTU per hour is converted to watts with the International Table value of 1055.05585262 joules per BTU divided by 3,600 seconds, about 0.29307 watts, and square metres are converted with 1 m² = 1 ÷ 0.3048² square feet.

Frequently asked questions

How many BTUs do I need for my room?

Find the floor area on the ENERGY STAR chart: 150 up to 250 square feet needs 6,000 BTU an hour, 250 up to 300 needs 7,000, and 300 up to 350 needs 8,000. Then adjust for sun, shade, the number of people and a kitchen.

What adjustments should I make?

ENERGY STAR says to reduce capacity by 10 percent if the room is heavily shaded and increase it by 10 percent if it is very sunny. Add 600 BTU for each person beyond two who regularly use the room, and 4,000 BTU if the unit is in a kitchen.

Is a bigger air conditioner better?

No. ENERGY STAR says a unit that is too big costs more, wastes energy and does not cool better. It cools the room before it has time to remove the humidity, so the air feels cool but clammy.

Does ceiling height matter?

The chart capacities are calculated for an 8-foot ceiling. With higher ceilings there is more air to cool, so ENERGY STAR suggests choosing a unit with higher capacity.

What does BTU per hour mean?

A British thermal unit is a quantity of heat, and BTU per hour is the rate at which the air conditioner removes heat. One BTU per hour is about 0.293 watts, so 8,000 BTU per hour is about 2,345 watts of cooling.

Does it work for a whole house?

No. The chart covers rooms from 100 to 2,500 square feet for room air conditioners. A whole house needs a proper load calculation by a heating and cooling professional, which looks at insulation, windows and climate.

Related calculators

Sources