Skip to content
thecalculatorstudio

Lean Body Mass Calculator (Boer, James, Hume)

Enter your sex, height and weight. You get your estimated lean body mass, and the fat mass left over, by four published formulas: Boer, James, Hume and Janmahasatian.

Last reviewed

cm
kg

Lean body mass (Boer)

56 kg

80% of your weight · the formulas span 52.8 to 56.5 kg

All four formulas
FormulaLean massFat massLean share
Boer56 kg14 kg80%
James56.5 kg13.5 kg80.7%
Hume52.8 kg17.2 kg75.4%
Janmahasatian55.9 kg14.1 kg79.8%
BMI
22.9
Height and weight used
175 cm, 70 kg

These are estimates from height and weight, not measurements. A body composition scan (such as DXA) measures lean mass directly. Fat mass here is weight minus lean mass. This page is information, not medical advice.

What lean body mass is

Lean body mass (LBM) is the weight of everything in the body except fat: muscle, bone, organs, skin and the water they hold. Your body weight is your lean body mass plus your fat mass. Doctors and researchers use lean mass because some drugs are better scaled to it than to total weight, and because scan measurements are often adjusted for it.

It is hard to measure directly. A body composition scan such as DXA does it, but most people only have their height and weight. So formulas have been fitted to scan data to estimate it.

The four formulas

Here W is weight in kilograms, H is height in centimetres and BMI is W ÷ (H ÷ 100)². The coefficients are as printed in a 2022 comparison of predictive equations in the British Journal of Radiology.

Formula Men Women
Boer (1984) 0.407 W + 0.267 H − 19.2 0.252 W + 0.473 H − 48.3
James (1976) 1.10 W − 128 (W ÷ H)² 1.07 W − 148 (W ÷ H)²
Hume (1966) 0.32810 W + 0.33929 H − 29.53 0.29569 W + 0.41813 H − 43.29
Janmahasatian (2005) 9270 W ÷ (6680 + 216 BMI) 9270 W ÷ (8780 + 244 BMI)

Worked example: a man of 175 cm and 70 kg

  • Boer: 0.407 × 70 + 0.267 × 175 − 19.2 = 28.49 + 46.725 − 19.2 = 56.0 kg.
  • James: 1.10 × 70 − 128 × (70 ÷ 175)² = 77 − 20.48 = 56.5 kg.
  • Hume: 0.3281 × 70 + 0.33929 × 175 − 29.53 = 52.8 kg.
  • Janmahasatian: BMI is 22.86, so 9270 × 70 ÷ (6680 + 216 × 22.86) = 55.9 kg.

The fat mass is the rest: about 14 kg by the Boer formula, which is 20% of the weight.

Examples

Person Height Weight Boer James Hume Janmahasatian
Man 175 cm 70 kg 56.0 56.5 52.8 55.9
Man 180 cm 90 kg 65.5 67.0 61.1 65.8
Man 170 cm 110 kg 71.0 67.4 64.2 68.4
Woman 165 cm 60 kg 44.9 44.6 43.4 39.3
Woman 160 cm 80 kg 47.5 48.6 47.3 45.2
Woman 170 cm 110 kg 59.8 55.7 60.3 56.4

The answers can differ by several kilograms. For the woman of 165 cm and 60 kg, the Janmahasatian formula gives 39.3 kg and the Boer formula 44.9 kg.

When the James formula stops working

The James formula subtracts a term that grows with the square of weight. Because of this, the lean mass it gives rises with weight up to a point, then falls. Setting the slope to zero gives the peak: W = 1.10 × H² ÷ 256 for men and W = 1.07 × H² ÷ 296 for women. For a man of 175 cm that is 131.6 kg, and for a woman of 170 cm it is 104.5 kg. Above those weights the formula says that gaining weight loses lean mass, which cannot be right, so the calculator marks it as unreliable and leaves it out of the range. The last row of the table shows this: a woman of 170 cm and 110 kg is above her peak, so the James figure of 55.7 kg is lower than the others.

How accurate is it?

These are estimates fitted to groups of people, using only height and weight, so they cannot see the difference between muscle and fat at a given weight. A 2022 study in the British Journal of Radiology compared ten equations with DXA scans of 1,558 people aged 60 to 65 and found that some came much closer than others. A person with a lot of muscle will have more lean mass than any of these shows, and a person with a lot of fat less. Treat the numbers as a rough guide.

Using the result

Lean mass is one part of what sets your resting energy use; see the BMR calculator. It is not a goal in itself. For a wider picture, look at the BMI calculator and the healthy weight calculator. For any medical decision, such as a drug dose that depends on lean mass, the formula is chosen by your care team. This page is information, not medical advice.

Common mistakes

  • Treating it as a measurement. It is an estimate from two numbers.
  • Mixing units. The formulas use kilograms and centimetres. The calculator converts pounds and inches for you.
  • Believing the James result at high weights. It peaks and then falls.
  • Reading the fat mass as a body fat test. These formulas were not built for that.

How it is calculated

Height and weight are converted to centimetres and kilograms if needed (1 inch = 2.54 cm, 1 lb = 0.45359237 kg). Each formula is evaluated in 40-digit decimal arithmetic with the coefficients above, and the results are rounded to one decimal place. Fat mass is weight minus lean mass.

Frequently asked questions

What is lean body mass?

Everything in the body that is not fat: muscle, bone, organs, skin and the water in them. Your weight is your lean body mass plus your fat mass. A man of 175 cm and 70 kg has an estimated lean body mass of about 56 kg by the Boer formula, which leaves about 14 kg of fat.

What is the Boer formula?

For men, LBM = 0.407 × weight (kg) + 0.267 × height (cm) − 19.2. For women, LBM = 0.252 × weight + 0.473 × height − 48.3. For a man of 70 kg and 175 cm that is 28.49 + 46.73 − 19.2 = 56.0 kg.

Why do the formulas disagree?

Each was fitted to a different group of people, and they all use only height and weight. For an average adult they differ by a few kilograms. At high body weights they diverge more, and the James formula in particular starts to fall as weight rises, so it stops making sense.

Is it accurate?

It is an estimate. A 2022 study compared ten equations with DXA scans of more than 1,500 people aged 60 to 65, and found large differences in how close they came. Only a body composition scan, such as DXA, measures lean mass directly.

What is it used for?

Lean body mass is used to scale some drug doses and to normalise scan measurements, such as the uptake in PET scans, for body size. It is also a starting point for energy estimates. Which equation to use in medicine is a clinical decision.

Can I use it to find my body fat percentage?

Roughly. Fat mass is weight minus lean mass, and fat percentage is fat mass divided by weight. But these formulas were not built to measure body fat, so the result is only a rough guide. The BMI and healthy weight calculators give other views.

Related calculators

Sources

This tool is for information only and is not medical advice. Speak to a doctor or a qualified professional about your own health.